/mcpCTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4_v6’. Application tries to do a static register of that CTI Port/Route Point to CTIManager with IPv4 address and Application addressing capability as IPv4. The registration will succeed and CTI Port/Route Point will get registered with CTIManager with IPv4 address. 3. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4_v6’. Application tries to do a static register of that CTI Port/Route Point to CTIManager with IPv4 and IPv6 addresses and Application addressing capability as IPv4_v6. The registration will succeed and CTI Port/Route Point will get registered with CTIManager with IPv4 and IPv6 addresses. 4. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4 only’. Application tries to do a static register of that CTI Port/Route Point to CTIManager with IPv4 address and Application addressing capability as IPv4. The registration will succeed and CTI Port/Route Point will get registered with CTIManager with IPv4 address. 5. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv6 only’. Application tries to do a static register of that CTI Port/Route Point to CTIManager with IPv6 address and Application addressing capability as IPv6. The registration will succeed and CTI Port/Route Point will get registered with CTIManager with IPv6 address. 6. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4 only’. Application tries a static register of that CTI Port/Route Point by providing an IPv6 address or/and by advertising application addressing capability as IPv6 (or Ipv4_v6) only then request will fail with a CiscoRegistrationException. 7. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv6 only’. Application tries to dynamically register that CTI Port/Route Point to CTIManager. IP capabilities advertised by the application at the time of registration are IPv4 (or IPv4_v6) only. Then the request will be denied with a CiscoRegistrationException. 8. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4 only (or IPv4_v6 both)’. Application tries to dynamically register that CTI Port/Route Point to CTIManager. IP capabilities advertised by the application at the time of registration are IPv4 only. Then the registration will succeed and CTI Port/Route point will get registered with IPv4 address when the same is provided with SetRTPParams request. 9. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv6 only (or IPv4_v6 both)’. Application tries to dynamically register that CTI Port/Route Point to CTIManager. IP capabilities advertised by the application at the time of registration are IPv6 only. Then the registration will succeed and CTI Port/Route point will get registered with IPv6 address when the same is provided with SetRTPParams request. 10. CTI Port/Route Point has ‘IP Addressing Mode’ configured as ‘IPv4_v6 both’. Application tries to dynamically register that CTI Port/Route Point to CTIManager. IP capabilities advertised by the application at the time of registration are IPv4_v6 both. Then the registration will succeed and CTI Port/Route point will get registered with IPv4_v6 address when the same is provided with SetRTPParams request. 11. If an application tries to dynamically register a CTI Port/Route Point by advertising its IP capabilities as IPv6, which is already registered to another application with IPv4 address. Then the request will be declined with a CiscoRegistrationException or “CiscoTermRegistrationFailedEv” will be sent with new reason code “IP_CAPABILITY_MISMATCH”. Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1155 Message Sequence Charts Message Sequence Charts