/mcpResult Action Scenario i) Registration successful. ii). After Calll Pickup Group notification time, applications gets CiscoProvPickupCallAlertEvent with calling A, Called B, pickup group number : N, pickup group partition: P1 iii). Application will get PlatformException with errorCTIERR_NO_CALLS_TO_PICKUPandcause NORMAL i) Application opens provider and issues provider. registerPickupAlert(N, P1) to register for pickup alert notification for call pickup group N:P1. ii). A calls B iii). A-B call goes IDLE. Then Application issues CiscoTerminal.otherPickup(Address of D) at D JTAPI Application is observing C, D. Cisco UCM service parameter AutoCallPickupEnabled is set to TRUE. i) PlatformException thrown with error CTIERR_INVALID_GROUP_NUMBER and cause NORMAL i). Application opens provider and issues provider. registerPickupAlert(K, P1) to register for pickup alert notification for call pickup group K:P1, where K is not a valid group number JTAPI Application is observing C, D. i). Registration successful ii.) Registration blocked at the JTAPI layer, and a InvalidStateException is thrown to the application with error CTIERR_ALREADY_REGISTERED and description “Pickup Group already registerred / observed”. i). Application opens provider and issues provider. registerPickupAlert(N, P1) to register for pickup alert notification for call pickup group N:P1. ii). Application again issues provider. registerPickupAlert(N, P1) to register for pickup alert notification for call pickup group N:P1. i). InvalidStateException thrown to application with error CTIERR_REGISTRATION_NOT_FOUND and description, “Pickup group is not registerred with this provider”. i). Application opens provider and issues provider.deregisterPickupAlert(N, P1) to deregister for pickup alert notification for call pickup group N:P1, which was not registerred for previously. i). Registration successful ii.) After Calll Pickup Group notification time, applications gets CiscoProvPickupCallAlertEvent with calling A, Called B, pickup group number : N, pickup group partition: P1 iii). A-B calls answered at J in P1. i). Application opens provider and issues provider. registerPickupAlert(N, P1) to register for pickup alert notification for call pickup group N:P1. ii.) A calls B. iii.) Application issues CiscoTerminal.pickup(Address of J in P1) at terminal of J in P1 JTAPI Application is observing J. Cisco UCM service parameter “AutoCallPickupEnabled” is set to true. J is an address in two partitions, P1 and P2. J belongs to the Pickup Group with number N. Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1245 Message Sequence Charts Message Sequence Charts