/mcpResult Expected Behavior Scenario Pre-Condition S.No. New partition information is reflected in the new address object. JTAPI will delete the current address object and create a new address object for A when it comes in service again. By querying the partition info of this address object, user should get changed partition info. Partition information of a DN is changed. JTAPI should reflect new partition information. A is an address in the control list of user and is opened by the user. From the CM admin page the partition information of A is changed. The device is restarted after this. 8 Persistent Connection Use Cases The following pre-conditions apply to all persistent call use cases, unless specified: • The provider is in IN_SERVICE state. • All addresses and terminals are already in service. • Device A (CTI Remote Device - Name: "CTIRDtapi", Line A1 (dn: 881000)) Remote destination 1 (Name: "rd", Number: "78000") • Device B (IP Phone - Name: "SEP001319ACCA26", Line B1 (dn: 1000)) • Device C (IP Phone - Name: "SEP00156247EE60", Line C1 (dn: 2000)) • User1 has in its control list: Devices A, B and C. All devices and lines are observed. Table 309: Call createPersistentCall() on an Address That Is Not Configured to a Remote Terminal Device, i.e. on an IP Phone Call Info Events Action ProvInServiceEv User1 opens Provider and adds a provider observer. Let "ex" be an instance of PlatformException: ((CiscoJtapiException) ex).getErrorCode() = CiscoJtapiException. COMMAND_NOT_IMPLEMENTED _ON_DEVICE. Caught exception com.cisco.jtapi.PlatformException: Internal callprocessing error :Device does not support the command User1 invokes CiscoAddress. createPersistentCall ("SEP00156247EE60", "5000", "remote") on device C. Table 310: Call createPersistentCall()on an Address That Is Configured to a Remote Terminal Device Where Active RD Is Not Set Call Info Events Action ProvInServiceEv User1 opens Provider and adds a provider observer. Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1343 Message Sequence Charts Persistent Connection Use Cases