McDewey

Scenario 32 FI: Call pick up- devRD (SME), RDD (cluster2), A (leaf), B (leaf)- RD selective recording Events and Call Info Setup and Action Step 5- After pickup, A1 and RD1 are connected. Step 6- Check recording started on RD1. Check RD1 get CiscoTermConnRecordingStartedEv and CiscoTermConnRecordingTargetInfoEv. Check RD1 TermConnection.getCiscoRecorderInfo(): .getRecordingType() = CALL_RECORDING_TYPE_APPLICATION _INITIATED_SILENT .getTerminalName() = central recorder device name .getAddress() = Recording profile (DN 2000) .getMediaForkingDeviceType() = CALL_RECORDING_MEDIA_FORKING_ DEVICE_TYPE_GW .getMediaForkingDeviceName() = SIP trunk device name - SIP GW .getProtocolReferenceGUID() = .getMediaForkingClusterID() = name of cluster1 Step 7- Check RD1 get CiscoTermConnRecordingEndedEv Cluster 1 (SME): • "Allow trunk use GW recording" is enabled • Central recorder: 2000 Cluster 2: Cluster 3 (leaf): • "Allow trunk use GW recording" is enabled • Branch recorder: 2000 • devRD (CTIRD3) on cluster 1 has line RD1 (9008) (active remote destination: 1711681 on cluster2) configured as: • selective recording enabled • GW preferred Remote Destination RDD on cluster 2. • devA (CTI1) on cluster 3 has line A1 (1600) configured as: • no recording • devB (SIP1) on cluster 3 has line B1 (9000) configured as: • no recording • A1 and B1 are in pick up group: PG_1 • Service parameter: auto pick up enabled 1. Open provider Prov1, Prov2, Prov3 2. Observe RD1, RDD1, A1, and B1 in Prov1/Prov2/Prov3 accordingly 3. RD1 call B1 4. After remote destination answer, call is offered to B1 and A1 5. A1 pick up the call 6. App start recording on RD1 7. App stop recording on RD1 8. RD1 disconnects the call Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1433 Message Sequence Charts Message Sequence Charts