McDewey

Scenario 2 Terminal gets unregistered due to Deep Sleep mode and the user tries to manually register the terminal during the Deep Sleep time. Information Events Description ProvInServiceEv P1 [Term A] CiscoTermInServiceEv [Addr A] CiscoAddrInServiceEv Application opens the provider and adds observer on provider, terminal and address of 'A'' CiscoProvTerminalUnRegisteredEv.getReason() = CiscoProvTerminalUnRegisteredEv. ENERGYWISE_POWER_ SAVE_PLUS CiscoTermOutOfServiceEv.getCause() = CiscoOutOfServiceEv. CAUSE_ENERGYWISE_POWER_ SAVE_PLUS CiscoAddrOutOfServiceEv.getCause() = CiscoOutOfServiceEv. CAUSE_ENERGYWISE_POWER_ SAVE_PLUS [Term A] CiscoProvTerminalUnRegisteredEv [Term A] CiscoTermOutOfServiceEv [Addr A] CiscoAddrOutOfServiceEv Terminal 'A' goes to Deep Sleep mode and gets unregistered Cisco Unified IP 7900 Series phones do not re-register with the Cisco Unified CM during the Deep Sleep time. This is a limitation of the phone. Cisco Unified IP 9900 and 6900 Series phones register back with the Cisco Unified CM by pressing the select key on the phone. A user tries to register the phone with Cisco Unified CM during deep sleep mode. [Term A] CiscoProvTerminalRegisteredEv [Term A] CiscoTermInServiceEv [Addr A] CiscoAddrInServiceEv Phone registers with the Cisco Unified CM after the Deep Sleep time expires. Scenario 3 Shared line scenario. Two devices A (Cisco Unified IP Phones 7900 Series phone) and A' (CTI Port) are configured with the same line. Deep Seep mode is enabled on device A Information Events Description ProvInServiceEv P1 [Term A] CiscoTermInServiceEv [Addr A] CiscoAddrInServiceEv [Term A'] CiscoTermInServiceEv [Addr A'] CiscoAddrInServiceEv Application opens the provider and adds observer on provider, terminal and address of A and A' Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 924 Message Sequence Charts Message Sequence Charts