McDewey

Secure Icons and Tones Configuration Tasks You can configure secure icons and secure tones using the following tasks: Procedure Purpose Command or Action Call Secure Status Policy outlines which media streams within a call must be encrypted for the Secure Icon feature Set up Call Secure Status Policy Step 1 to display the call as Encrypted. The default is that audio and video (for video calls) must both be encrypted. You can reconfigure the setting to consider BFCP and iX Channel as well. Enable the secure indication tone on a protected phone. Enable Secure Indication Tone Step 2 Configure supported Cisco Unified IP Phones as protected devices in Unified Communications Manager. Configure Phone as a Protected Device Step 3 Set Up Secure Icon Policy Call Secure Status Policy controls display of secure status icon on phones. The following are the policy options: • All media except BFCP and iX application streams must be encrypted This is the default value. The security status of the call is not dependent on the encryption status of BFCP and iX application streams. • All media except iX application streams must be encrypted The security status of the call is not dependent on the encryption status iX application streams. • All media except BFCP application streams must be encrypted The security status of the call is not dependent on the encryption status BFCP. • All media in a session must be encrypted The security status of the call is dependent on the encryption status of all the media streams of an established phone session. • Only Audio must be encrypted The security status of the call is dependent on the encryption of the audio stream. Changes to the policy impacts display of the secure icon and playing of secure tone on the phone. Note Security Guide for Cisco Unified Communications Manager, Release 15 and SUs 177 Basic System Security Secure Icons and Tones Configuration Tasks