McDewey

Reset Devices, Servers, Clusters, and Services This section provides information on when to reset devices, servers, clusters, and services in Cisco Unified Serviceability. To reset all devices in a cluster, perform the following procedure: Procedure Step 1 From Unified Communications Manager, choose System > CiscoUnifiedCM. Step 2 Click Find. A list of configured Unified Communications Manager servers appears. Step 3 Choose the Unified Communications Manager on which you want to reset devices. Step 4 Click Reset. Step 5 Perform Step 2 and Step 4 for each server in the cluster. Media Encryption with Barge Setup Configure barge for Cisco Unified IP Phones 7962 and 7942 for encryption and perform the following tasks in Cisco Unified Communications Manager Administration. • Update the Cluster Security Mode using CLI commands (utils ctl set cluster mixed-mode). • Update the Builtin Bridge Enable parameter in the Service Parameter window. On completion of the tasks, the following message appears. If you configure encryption for Cisco Unified IP Phone models 7962 and 7942, the encrypted devices can't accept a barge request when they are participating in an encrypted call. The barge attempt fails when the call is encrypted. Attention Cisco Unified IP Phones 7962 and 7942 configured with an encrypted security profile doesn't display the message in the Phone Configuration window. You choose Default for the Built In Bridge setting or the default setting equals Default. The same restriction applies for either selection. Reset the dependent CiscoIP devices for changes to take effect. Tip Common Icons Unified Communications Manager provides a security status for calls based on security levels configured for all servers and devices participating in the call. Security Guide for Cisco Unified Communications Manager, Release 15 and SUs 7 An Introduction to Unified CM Security Reset Devices, Servers, Clusters, and Services