/mcpPIMG/TIMG Units If the phone systems are integrated through PIMG/TIMG units, each PIMG/TIMG unit is created in a separate port group. You can add, change, or delete PIMG/TIMG units after the phone system integration has been created. In Unity Connection, integration with multiple phone systems is supported only with Cisco Business Edition 6000/7000. Note Configuring PIMG/TIMG Units Procedure Step 1 In Cisco Unity Connection Administration, expand Telephony Integrations and select Port Group. The Search Port Groups page displays the currently configured PIMG/ TIMG units. Step 2 Configure a PIMG/TIMG unit (For more information on each field, see Help> This Page): • To add a PIMG/TIMG unit, in Port Group Search Results, select Add New. On the New Port Group page, in the Phone System field, select the phone system for which you want to add a PIMG/TIMG unit. Enter the applicable settings and select Save. • To edit a PIMG/TIMG unit, select the display name of the port group for which you want to change PIMG/TIMG settings. On the Port Group Basics page, in PIMG Settings, enter the applicable settings and select Save. • To delete a PIMG/TMG unit, in Port Group Search Results, check the check box next to the port group for the PIMG/TIMG unit that you want to delete. Select Delete Selected and then select OK to confirm deletion. Advanced Settings The port group advanced settings control the settings that are not often used, such as delays and MWI usage. Do not change the default values of port group advanced settings. Normalization controls automatic volume adjustments for recording messages. For enabling or disabling normalization, make sure to leave normalization enabled and do not change the value of the Target Decibel Level for Recordings and Messages field in System Settings > General Configuration. Editing Port Group Advanced Settings Procedure Step 1 In Cisco Unity Connection Administration, expand Telephony Integrations, and then select Port Group. On the Search Port Groups page, select the display name of the port group for which you want to change the advanced settings. Step 2 On the Port Group Basics page, on the Edit menu, select Advanced Settings and do the following: System Administration Guide 73 Telephony Integration PIMG/TIMG Units