McDewey

Requirements Command privilege level: 1 Allowed during upgrade: No utils EnhancedSecurityMode This command allows you to check and change Enhanced Security Mode status on a particular node. Command Syntax Result Command This command allows you to change and check Enhanced Security Mode status on a particular node. When Enhanced Security Mode is enabled, the system implements a set of strict security and risk management controls that allow your system to comply with the Enhanced Security Mode guidelines. utils EnhancedSecurityMode Run this command to disable a cluster node for Enhanced Security Mode. utils EnhancedSecurityMode disable Run this command to enable a cluster node for Enhanced Security Mode. utils EnhancedSecurityMode enable Run this command to verify if Enhanced Security Mode is enabled. utils EnhancedSecurityMode status Syntax Description Description Parameters Deactivates Enhanced Security Mode and prompts disabling of FIPS mode. disable Activates Enhanced Security Mode and prompts for enabling FIPS mode. If FIPS mode is enabled, then Enhanced Security Mode will be activated. enable Displays the status of Enhanced Security Mode. status Usage Guidelines FIPS mode must be enabled before you enable Enhanced Security Mode. If you haven't already enabled FIPS, you will be prompted to enable it when you attempt to enable Enhanced Security Mode. FIPS Mode and Enhanced Security Mode do not support MD5 or DES encryption methods. If SNMPv3 setting is enabled using both MD5 and DES, then enabling FIPS Mode or Enhanced Security Mode changes these encryption methods to SHA-1 and AES-128 respectively. Note Cisco Emergency Responder Command Line Interface Guide for Release 15 105 CLI Commands utils EnhancedSecurityMode