/mcp• An administrator ID • An administrator password You need this information to log in to the Emergency Responder platform. Procedure Step 1 Depending on your method of access, do one of the following actions: • From a remote system, use SSH to connect securely to the Emergency Responder platform. In your SSH client, enter: ssh adminname@hostname adminnam specifies the administrator ID and hostname specifies the hostname that was defined during installation. For example, ssh admin@cer-1 • From a direct connection, you receive this prompt automatically: cer-1 login: cer-1 represents the host name of the system. Enter the administrator ID that was defined during installation. Step 2 Enter the password that was defined at installation. The CLI prompt appears. The prompt represents the administrator ID; for example: admin: You can now use any CLI command. Command Completion To complete commands, use Tab: Procedure • Enter the start of a command and press Tab to complete the command. For example, if you enter se and press Tab, se is expanded to the set command. • Enter a full command name and press Tab to display all the commands or subcommands that are available. For example, if you enter set and press Tab, you see all of the set subcommands. An asterisk (*) identifies the commands that have subcommands. • PressTab to continue. The current command line repeats; no additional expansion is available. Cisco Emergency Responder Command Line Interface Guide for Release 15 4 CLI Basics Command Completion