McDewey

yes executing... set network nic This command sets the properties of the Ethernet interface 0. You cannot configure Ethernet interface 1. Command Syntax set network nic eth0{auto{ en | dis}} {speed | {10 | 100} } {duplex| {half | full}} Syntax Description Description Parameters Specifies Ethernet interface 0. eth0 Specifies whether auto negotiation gets enabled or disabled. auto Specifies the speed of the Ethernet connection: 10 or 100 Mbps. speed Specifies half-duplex or full-duplex. duplex Usage Guidelines The system asks whether you want to continue to execute this command. If you continue, this command causes a temporary loss of network connections while the NIC gets reset. Caution You can enable only one active NIC at a time. Note Requirements Command privilege level: 1 Allowed during upgrade: No set network ntp option This command adds a noquery option to /etc/config file. Command Syntax set network ntp option noquery set network pmtud This command enables and disables path MTU discovery. Cisco Emergency Responder Command Line Interface Guide for Release 15 41 CLI Commands set network nic