/mcpUsage Guidelines The system asks whether you want to continue to execute this command. If you continue, the system loses network connectivity temporarily. Caution Requirements Command privilege level: 1 Allowed during upgrade: No Applies to: Unified Communications Manager, IM and Presence Service on Unified Communications Manager, and Cisco Unity Connection. Example admin:set network pmtud state enable W A R N I N G This will cause the system to temporarily lose network connectivity Do you want to continue ? Enter "yes" to continue or any other key to abort yes executing... set network restore This command configures the specified Ethernet port to use a specified static IP address. set network restore eth0 ip-address network-mask gateway Syntax Description Description Parameters Specifies Ethernet interface 0. eth0 Represents the IP address of the primary or secondary DNS server, or the network gateway that you want to assign. If you continue, this command causes a temporary loss of network connectivity. If you change the IP address for the primary DNS server, you must also restart the Cisco Tomcat service. For more information, see the utils service command. We also recommend that you restart all nodes whenever any IP address gets changed. ip-address Represents the subnet mask for the server. network-mask Specifies the IP address of the default gateway. gateway Represents the IP address of the primary or secondary DNS server, or the network gateway that you want to assign. If you continue, this command causes a temporary loss of network connectivity. If you change the IP address for the primary DNS server, you must also restart the Cisco Tomcat service. For more information, see the utils service command. We also recommend that you restart all nodes whenever any IP address gets changed. ip-address Command Modes Administrator (admin:) Command Line Interface Reference Guide for Cisco Unified Communications Solutions, Release 15 and SUs 108 Set Commands set network restore