McDewey

set network cluster subscriber dynamic-cluster-configuration Use this command to enable the Dynamic Cluster Configuration on the publisher. Use this command to specify the duration in which you can add subscriber nodes to the publisher server table. The addition of subscriber nodes is authenticated immediately and those nodes need not wait for the publisher details during the installation of the subscriber nodes. set network cluster subscriber dynamic-cluster-configuration {default | no. of hours} Syntax Description Description Parameter Enables the Dynamic Cluster Configuration for 24 hours. default Specifies a value from 1 to 24 hours. no. of hours Command Modes Administrator (admin) Requirements Applies to Unified Communications Manager, IM and Presence Service, and Cisco Unity Connection set network dhcp eth0 This command enables or disables DHCP for Ethernet interface 0. You cannot configure Ethernet interface 1. set network dhcp eth0 {enable | disable } {node_ipnet_maskgateway_ip } Syntax Description Description Parameters Specifies Ethernet interface 0. eth0 This enables DHCP. enable This disables DHCP. disable Represents the static IP address for the server. node_ip Represents the subnet mask for the server. net_mask Represents the IP address of the default gateway. gateway_ip Command Modes Administrator (admin:) Command Line Interface Reference Guide for Cisco Unified Communications Solutions, Release 15 and SUs 90 Set Commands set network cluster subscriber dynamic-cluster-configuration