/mcpDescription Setting Advanced Clusterwide parameters Important Configure unique IP addresses for each pool so that the same Cisco IPMA server IP address does not appear in more tha This parameter determines whether multiple instances of the Cisco IP Manager Assistant run for scalability. If it is enabled, Cisco IPMA can run on the other nodes as configured Pool 3 parameters. To enable multiple active mode, you must enter the IP addresses of the nodes on which y the additional instances of Cisco IPMA. Configure the Cisco IP Manager Assistant servic those nodes. Default value: False Enable Multiple Active Mode If multiple active mode is enabled, this parameter specifies the IP address of the primary Ci of the second instance of Cisco IPMA. Configure the Cisco IP Manager Assistant service parameters on this node. Pool 2: Cisco IPMA Server (Primary) IP Address If multiple active mode is enabled, this parameter specifies the IP address of the backup Ci of the second instance of Cisco IPMA. The backup server provides IPMA service when th server fails. Configure the Cisco IP Manager Assistant service parameters on this node. Pool 2: Cisco IPMA Server (Backup) IP Address If multiple active mode is enabled, this parameter specifies the IP address of the primary Ci of the third instance of Cisco IPMA. Configure the Cisco IP Manager Assistant service parameters on this node. Pool 3: Cisco IPMA Server (Primary) IP Address If multiple active mode is enabled, this parameter specifies the IP address of the primary Ci of the third instance of Cisco IPMA. The backup server provides IPMA service when the server fails. Configure the Cisco IP Manager Assistant service parameters on this node. Pool 3: Cisco IPMA Server (Backup) IP Address Clusterwide Parameters (Softkey Templates) Important Configure these parameters if you want to use the Manager Assistant automatic configuration for managers and assistan This parameter specifies the assistant softkey template that is assigned to assistant devices d Configuration. The value that is specified in this parameter is used when the Automatic C check box is checked on the Cisco IPMA Assistant Configuration page. Assistant Softkey Template This parameter specifies the manager softkey template for proxy mode that is assigned to during Automatic Configuration. This parameter applies only for managers that use proxy Manager Softkey Template for Proxy Mode Clusterwide Parameters (IPMA Device Configuration Defaults for Proxy Mode) This parameter defines the partition that is assigned to manager lines that IPMA handles on during Automatic Configuration. Make sure the partition you want to use has already bee Unified CM Administration. If the Cisco IPMA Configuration Wizard is run, it will pop This parameter applies only for managers that use proxy mode. Manager Partition Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 166 Call Center Features Manager Assistant Service Parameters for Proxy Line