/mcpYou cannot apply feature group template edits to an LDAP directory sync where the initial sync has already occurred. To apply these edits to an LDAP sync, the initial sync must not yet have occurred. Note Procedure Step 1 From Cisco Unified CM Administration, choose User Management > User Phone/Add > Feature Group Template. Step 2 Do either of the following: • Select Find and select an existing template. • Click Add New to create a new template. Step 3 From the drop-down list, select a Service Profile. Step 4 From the drop-down list, select a User Profile. Step 5 Check the Enable End User to Host Conference Now check box. Step 6 Click Save. What to do next Assign the template to an LDAP directory sync so that synced users will be configured for Conference Now. For more information on configuring an LDAP sync, see the "Configure End Users" section of the System Configuration Guide for Cisco Unified Communications Manager. Alternatively, you can add a new user with Conference Now functionality via the Quick User/Phone Add menu. You would need to add a new user that uses this feature group template in addition to assigning a primary extension. Conference Now Interactions Interactions Feature A mobility user dials an Enterprise Feature Access DID number from a remote destination. After the call is connected, the remote destination phone is used to send DTMF digits to Unified Communications Manager via the PSTN gateway. The user PIN followed by the # key is first authenticated with Unified Communications Manager. After the user PIN authentication is successful, press 1 and the # key, to indicate a two-stage dialed call, followed by the desired phone number. If the dialed phone number is a Conference Now IVR Directory Number and the user is a meeting host, then the user must enter the PIN again. Mobility EFA (Enterprise Feature Access) Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 240 Conferencing Features Conference Now Interactions