/mcpThe partition that is assigned to the call park number does not match the partition that is assigned to the phone directory number. For more information on partition, see the System Configuration Guide for Cisco Unified Communications Manager. Call Park Number is Not Displayed Long Enough Problem The call park number is not displayed long enough for the user. Solution Set the Call Park Display Timer to a longer duration. See Configure Clusterwide Call Park, on page 378 for more information about the Timer. Directed Call Park Overview Directed Call Park allows a user to transfer a call to an available user-selected directed call park number. Configured Directed Call Park numbers exist cluster-wide. You can configure phones that support the directed call park Busy Lamp Field (BLF) to monitor the busy or idle status of specific directed call park numbers. Users can also use the BLF to speed dial a directed call park number. Unified Communications Manager can park only one call at each directed call park number. To retrieve a parked call, a user must dial a configured retrieval prefix followed by the directed call park number at which the call is parked. Directed Call Park Prerequisites Make sure that the phones in your deployment support Directed Call Park. For a list of supported phones, run the Phone Feature List report from Cisco Unified Reporting, selecting Assisted Directed Call Park as the feature. For details, see Generate a Phone Feature List, on page 5. Directed Call Park Configuration Task Flow Before you begin • Review Directed Call Park Prerequisites, on page 393 Procedure Purpose Command or Action To configure clusterwide parameter for directed call park. Configure ClusterWide Directed Call Park, on page 394 Step 1 Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 393 Receiving Calls Call Park Number is Not Displayed Long Enough