/mcpSynchronize Security Groups from LDAP Directory Add your Security Group filter to an LDAP Directory sync and complete a sync. You cannot add new configurations into an existing LDAP Directory configuration in Cisco Unified Communications Manager if the initial LDAP sync has already occurred. Note For detailed information on how to set up a new LDAP Directory sync, see the "Configure End Users" part of the System Configuration Guide for Cisco Unified Communications Manager. Note Before you begin Create Security Group Filter, on page 660 Procedure Step 1 In Cisco Unified CM Administration, choose System > LDAP > LDAP Directory. Step 2 Do one of the following: • Click Add New to create a new LDAP Directory. • Click Find and select the LDAP Directory from which the security groups will be synchronized. Step 3 From the LDAP Custom Filter for Groups drop-down list, select the security group filter that you created. Step 4 Click Save. Step 5 Configure any remaining fields in the LDAP Directory Configuration window. For more information on the fields and their configuration options, see Online Help. Step 6 Click Perform Full Sync Now to synchronize immediately. Otherwise, security groups will be synchronized when the next scheduled LDAP sync occurs. Configure Cisco Jabber for Security Groups Update existing service profiles to allow Cisco Jabber users whom are associated to that service profile to add security groups from an LDAP directory to their contact lists. For information on how to set up new service profiles and assign them to Cisco Jabber users, see the "Configure Service Profiles" chapter of the System Configuration Guide for Cisco Unified Communications Manager. Note Before you begin Synchronize Security Groups from LDAP Directory, on page 661 Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 661 Custom Features Synchronize Security Groups from LDAP Directory