/mcpset of parameters. The new layout ensures that you have a complete list of Cisco TelePresence settings on the Cisco Unified CM Administration interface. • Automatic migration of the configuration data from the video endpoints—This simplifies the deployment of endpoints by automatically synching data from endpoints to Unified Communications Manager and vice versa. Endpoint configurations can be fully restored in case of reset to factory settings or Product Returns & Replacements (RMA) swaps. Any endpoint that supports Collaboration Endpoint (CE) Software 9.8 or higher can use this new provisioning layout for the Product-Specific Configuration fields on the Phone Configuration page. If you are using a CE software version prior to 9.8, you will be able to view all the new set of advanced parameters; but, the new set of parameters functions only if you upgrade your CE Software version to 9.8 or higher. The subset of parameters supported is marked with a “#” to the right of each parameter value in the user interface. You must load a device pack onto Unified Communications Manager if a device type is capable of supporting the new provisioning framework, but does not show the additional parameters. Note Video Endpoints Management Feature Compatibility Following table details the video endpoints management feature compatibility with Unified Communications Manager and Collaboration Endpoint (CE) versions: Expected Behavior CE Endpoint Version Unified Communications Manager Version Devices added prior to 12.5(1) SU1: • Advanced Configuration UI (Tabbed Layout) for successfully backed up devices • Limited Configuration UI (Flat Layout) for devices yet to be backed up New device added through UI/BAT/AXL: • Advanced Configuration UI Note It's highly recommended that you run CE 9.8 or higher. 9.8 and above 12.5(1) SU1 Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 718 Device Management Video Endpoints Management Feature Compatibility