/mcpWhat to do Existing Configuration Summary Task So long as the CE endpoint is at a supported version, when you upgrade Unified CM, the Advanced Configuration settings from the endpoint get pulled into Unified CM automatically following device registration and display under the Product-Specific Configuration section of the Phone Configuration window. After registration, you can set the Configuration Control Mode in addition to whatever settings you want. • Existing device • Device is provisioned on a pre-12.5 release of Unified CM • Unified CM has a limited set of Product-Specific Configuration settings for the device Upgrading from an Earlier Release of Unified CM with Registered Video Endpoints Add Migrating Video Endpoint to Unified CM If you are migrating existing Cisco TelePresence Video Endpoints from a Cisco TelePresence Video Communications Server to Unified Communications Manager, use this procedure to add the CE endpoint into Unified CM via the Phone Configuration window so that the existing Advanced Configurations from the endpoint can be managed from the Phone Configuration window in Unified CM. Make sure to follow this procedure closely. The settings from the endpoint do not automatically upload to Unified CM until after device registration. Note This procedure uses the Add New from Template setting in the Unified CM Phone Configuration window. You can also use tools like Bulk Administration or AXL to add the endpoint. Note Before you begin It's highly recommended that you upgrade firmware to CE 9.8 or higher before you migrate. With CE 9.7 or earlier, Unified CM overwrites the existing endpoint configuration during registration with default settings. Procedure Step 1 From Cisco Unified CM Administration, choose Device > Phone. Step 2 Click Add New from Template and enter the following phone details: • Select the model from the Phone Type drop-down list. • Enter the MAC Address of the endpoint • From the Device Template, select a Universal Device Template. • Select the Directory Number that you want to add to the phone. If none exists, click New and configure a directory number. • From the User drop-down list, select the user whom will own the device. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 722 Device Management Add Migrating Video Endpoint to Unified CM