/mcpmatch occurred, your system uses the calling search space that is configured for the translation pattern to perform the subsequent match. Procedure Step 1 In Cisco Unified CM Administration, choose Call Routing > Translation Pattern. Step 2 Perform one of the following tasks: • To modify the settings for an existing translation pattern, enter search criteria, click Find, and choose an existing Translation Pattern from the resulting list. • To add a new translation pattern, click Add New. Step 3 From the MLPP Precedence drop-down list, choose one of the following settings for this translation pattern: • Executive Override—Highest precedence setting for MLPP calls. • Flash Override—Second highest precedence setting for MLPP calls. • Flash—Third highest precedence setting for MLPP calls. • Immediate—Fourth highest precedence setting for MLPP calls. • Priority—Fifth highest precedence setting for MLPP calls. • Routine—Lowest precedence setting for MLPP calls. • Default—Does not override the incoming precedence level but rather lets it pass unchanged. Step 4 From the Resource-Priority Namespace Network Domain drop-down list, choose a resource priority namespace network domain that you configured. Step 5 From the Calling Search Space drop-down list, choose the calling search space that you configured. Step 6 Click Save. Configure Multilevel Precedence and Preemption for Gateways Configure Cisco Unified Communications Manager to communicate with non-IP telecommunications devices. Before you begin • Configure one of the following gateways: • Cisco Catalyst 6000 24 port FXS Gateway • Cisco Catalyst 6000 E1 VoIP Gateway • Cisco Catalyst 6000 T1 VoIP Gateway • Cisco DE-30+ Gateway • Cisco DT-24+ Gateway • H.323 Gateway Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 835 QoS Management Configure Multilevel Precedence and Preemption for Gateways