/mcpScenario 6 IP phones (Basic): Multi-Clusters Hold and resume - Gateway preferred with automatic recording Events and Call Info Setup and Action Step 4-Check A1 get CiscoTermConnRecordingStartedEv and CiscoTermConnRecordingTargetInfoEv. Check A1 TermConnection.getCiscoRecorderInfo(): .getRecordingType() = CALL_RECORDING_TYPE_AUTOMATIC .getTerminalName() = central recorder device name .getAddress() = Recording profile (DN 2000) .getMediaForkingDeviceType() = CALL_RECORDING_MEDIA_FORKING_DEVICE_TYPE_GW .getMediaForkingDeviceName() = SIP trunk device name – SIP GW .getProtocolReferenceGUID() = .getMediaForkingClusterID() = name of cluster1 Check B1 TermConnection.getCiscoRecorderInfo(): .getRecordingType() = CALL_RECORDING_TYPE_AUTOMATIC .getTerminalName() = recorder B device name .getAddress() = Recording profile (DN 2000) .getMediaForkingDeviceType() = CALL_RECORDING_MEDIA_FORKING_DEVICE_TYPE_GW .getMediaForkingDeviceName() = SIP trunk 2 device name – SIP GW .getProtocolReferenceGUID() = .getMediaForkingClusterID() = name of cluster2 Step 5- Check A1 get CiscoTermConnRecordingEndEv Step 6- Check A1 get CiscoTermConnRecordingStartedEv and CiscoTermConnRecordingTargetInfoEv. Step 7- Check A1 get CiscoTermConnRecordingEndEv Cluster 1: • “Allow trunk use GW recording” is enabled • Central recorder: 2000 Cluster 2: • Phone B ( SEP8E0E) has line B1:4006 • GW preferred • auto recording enabled • recorder B:2000 Cluster 3: • Branch recorder: 2000 • GW preferred • auto recording enabled • recording profile:rec_profile1: 2000 • Phone A ( SEP3B5F) has line A1 3602 configured as: 1. Open provider Prov1, Prov2, Prov3 2. Observe A1 in Prov3, B1 in Prov2 3. A1 call B1 (3602 call 1721714006) 4. B1 answer the call 5. A1 put call on hold 6. A1 resume the call 7. A1 drop Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1401 Message Sequence Charts Message Sequence Charts