McDewey

Step 4- Check auto recording started on A1. Check A1 get CiscoTermConnRecordingStartedEv and CiscoTermConnRecordingTargetInfoEv. Check A1 TermConnection.getCiscoRecorderInfo(): .getRecordingType() = CALL_RECORDING_TYPE_AUTOMATIC .getTerminalName() = central recorder device name .getAddress() = Recording profile (DN 2000) .getMediaForkingDeviceType() = CALL_RECORDING_MEDIA_FORKING_DEVICE_TYPE_GW .getMediaForkingDeviceName() = SIP trunk device name - SIP GW .getProtocolReferenceGUID() = .getMediaForkingClusterID() = name of cluster1 Step 5- Check A1 get CiscoTermConnRecordingEndEv Step 6- Check A1 get CiscoTermConnRecordingStartedEv and CiscoTermConnRecordingTargetInfoEv. Check A1 TermConnection.getCiscoRecorderInfo(): .getRecordingType() = CALL_RECORDING_TYPE_AUTOMATIC .getTerminalName() = central recorder device name .getAddress() = Recording profile (DN 2000) .getMediaForkingDeviceType() = CALL_RECORDING_MEDIA_FORKING_DEVICE_TYPE_GW .getMediaForkingDeviceName() = SIP trunk device name - SIP GW .getProtocolReferenceGUID() = .getMediaForkingClusterID() = name of cluster1 Step 7- Check A1 get CiscoTermConnRecordingEndEv Cluster 1: • “Allow trunk use GW recording” is enabled • Central recorder: 2000 • Mobile through PSTN GW in Cluster 1 Cluster 2: • devB (CTI_RD3) has line B1:1620 (remote destination: 1722602 on cluster 1) configured as: • auto recording enabled • GW preferred Cluster 3: • Branch recorder: 2000 • devA (IP phone) has line 3602 configured as: • GW preferred • auto recording enabled • recording profile:rec_profile2: 2000 1. Open provider Prov1, Prov2, Prov3 2. Observe A1 in Prov3, B1 in Prov2 3. A1 (cluster 3) call B1 (cluster2) 4. Remote destination of devB answer the call 5. A1 put call on hold 6. A1 resume the call 7. A1 drop Cisco Unified JTAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 1409 Message Sequence Charts Message Sequence Charts