/mcpd) The default FromDate value specifies the ToDate value minus 1hour. For example, if ToDate = January 15, 2007 12:00:00, the FromDate default value = January 15, 2007 11:00:00 (all times in UTC). Step 7 Choose whether to run the CDR Search report with grouping or without grouping. If you chose with grouping, check the check box beside With Grouping. The default specifies Without Grouping. Note With Grouping choice means that the system returns CDR records that match the date and time range for the search, and groups them with their associated records. Without Grouping returns all the CDR records that match the date and time range without grouping all the associated records for each call. Step 8 Click OK. The CDR-CMR Results window displays. The system only displays the oldest 100 records that fall into the date and time range that you configured in Step 6, on page 185. If more than 100 records are returned, the system truncates the results. Step 9 To view the CMR data, click Others . To view both the CDR and CMR data fields, click View. Step 10 To mail the report to e-mail recipient(s), follow the steps in the Mail Reports, on page 63. Generate CDR Search by Cause for Call Termination Only CAR administrators use the CDR Search by Cause for Call Termination feature. The following tables contain the call termination cause codes by which you may search. Table 81: Call Termination Cause Codes Description Code No error 0 Unallocated (unassigned) number 1 No route to specified transit network (national use) 2 No route to destination 3 Send special information tone 4 Misdialed trunk prefix (national use) 5 Channel unacceptable 6 Call awarded and being delivered in an established channel 7 Preemption 8 Preemption - circuit reserved for reuse 9 Normal call clearing 16 User busy 17 Call Reporting and Billing Administration Guide for Cisco Unified Communications Manager, Release 15 and SUs 186 CDR Analysis and Reporting Generate CDR Search by Cause for Call Termination