/mcpStep 2 In the Reports [Report Generation Interval] box, choose the report that you want to automatically generate based on the schedule that you defined in the System Scheduler. See the Set Up CDR Load Schedule, on page 36. Step 3 In the Status field, choose Enabled or Disabled. Step 4 To customize the report or have the report emailed when it is generated, click Customize Parameters. The Customize Parameters window displays. Note Each report provides different customization options, depending on the type of report. Step 5 Choose the CSV or PDF radio button, depending on the type of report that you want the system to mail. Step 6 To have the report mailed to all CAR administrators, check the Mailing Option check box. Step 7 To save the values that you specified, click Update. The Customize Parameters window closes. Step 8 To enable or customize other reports, repeat the previous steps. Step 9 Click Update. Changes take effect at midnight. You can force the change to take effect immediately by stopping and restarting the CAR Scheduler service. Enable Email Alerts There are two Alerts by Mail that are available. These alerts are: • Charge Limit Notification • QoS Notification See the Set Notification Limits, on page 59 for information on how to configure these alerts. This section describes how to enable these alerts to be mailed to users. Procedure Step 1 Choose Report Config > Automatic Generation/Alert. The Automatic Report Generation/Alert window displays. Step 2 In the Alerts by Mail box, choose the alert that you want to enable or disable. Step 3 In the Status field, choose Enabled or Disabled. Step 4 Click Update. Step 5 To enable or disable alerts by mail, repeat the previous steps. Changes take effect at midnight. You can force the change to take effect immediately by stopping and restarting the CAR Scheduler service. Call Reporting and Billing Administration Guide for Cisco Unified Communications Manager, Release 15 and SUs 58 CDR Analysis and Reporting Enable Email Alerts