/mcpProcedure Step 1 Choose Call Routing > Meet-Me Number/Pattern. Step 2 In the Find and List Conference Bridges window, verify that the Meet-Me number/pattern is configured and go to Set Up Secure Conference Bridge, on page 166. Step 3 If the Meet-Me number/pattern is not configured, click Add New; go to Set Up Minimum Security Level for Meet-Me Conferences, on page 167. Step 4 In the Meet-Me Number Configuration window, enter a Meet-Me number or range in the Directory Number or Pattern field. Configure the Description and Partition settings as described in the Feature Configuration Guide for Cisco Unified Communications Manager. Step 5 In the Minimum Security Level field, select Non Secure, Authenticated, or Encrypted. Step 6 Click Save. What to do next If you have not yet installed a secure conference bridge, install and configure a secure conference bridge. Set Up Packet Capturing for Secure Conference Bridge To configure packet capturing for a secure conference bridge, enable packet capturing in the Service Parameter Configuration window; then, set the packet capture mode to batch mode and capture tier to SRTP for the phone, gateway, or trunk in the device configuration window. Refer to the Troubleshooting Guide for Cisco Unified Communications Manager for more information. During a packet capture session, the phone displays a nonsecure status for the conference, even if the media stream is encrypted. Security Guide for Cisco Unified Communications Manager, Release 15 and SUs 168 Basic System Security Set Up Packet Capturing for Secure Conference Bridge