/mcpError Message %UC_SAMLSSO-6-SAMLSSODisableSuccess: %[AppID=String][ClusterID=String] [NodeID=String]: SAML SSO disable operation successful. Explanation This alarm indicates that operation to disable SAML SSO was successful. Recommended Action Informational alarm. No action required. Error Message %UC_SAMLSSO-3-SAMLSSODisableFailure: %[ErrorDetails=String][AppID=String][ClusterID=String] [NodeID=String]: SAML SSO disable operation failed. Explanation This alarm indicates that operation to disable SAML SSO has failed. Recommended Action In the Cisco Unified Reporting tool, run a CM Cluster Overview report and check the SAML SSO status on other nodes in the cluster to determine if operation has failed on other nodes as well. Verify that there is no connectivity issues between the node from where the disable operation is initiated and the node(s) where the operation failed. If the disable operation was performed from the web pages, the same can be tried from the CLI (of the node where the disable failed) using command "utils sso disable". If the disable still fails, use RTMT to collect traces for Cisco SSO and contact Cisco TAC for assistance. Alternately, use CLI to collect traces by running the commands 'file get activelog tomcat/logs/ssosp/log4j/.log' and 'file get activelog platform/log/ssoApp.log'. Error Message %UC_LPMTCT-4-LogPartitionLowWaterMarkExceeded: %[UsedDiskSpace=String] [{Optional}MessageString=String][AppID=String][ClusterID=String][NodeID=String]: The percentage of used disk space in the log partition has exceeded the configured low water mark.. Explanation The percentage of used disk space in the log partition has exceeded the configured low water mark. Recommended Action Login into RTMT and check the configured threshold value for LogPartitionLowWaterMarkExceeded alert in Alert Central. If the configured value is set to a lower than the default threshold value unintentionally, change the value to default. Also, examine the trace and log file setting for each of the application in trace configuration page under CCM Serviceability. If the number of configured traces / logs is set to greater than 1000, adjust the trace settings from trace configuration page to default. Also, clean up the trace files that are less than a week old. You can clean up the traces using cli "file delete" or using Remote Browse from RTMT Trace and Log Central function. Error Message %UC_LPMTCT-2-LogPartitionHighWaterMarkExceeded: %[UsedDiskSpace=String] [{Optional}MessageString=String][AppID=String][ClusterID=String][NodeID=String]: The percentage of used disk space in the log partition has exceeded the configured high water mark.. Explanation The percentage of used disk space in the log partition has exceeded the configured high water mark. Some of the core file and / or trace files will be purged until the percentage of used disk space in the log partition gets below the configured low water mark. Recommended Action Login into RTMT and check the configured threshold value for LogPartitionHighWaterMarkExceeded alert in Alert Central. If the configured value is set to a lower than the default threshold value unintentionally, change the value to default. If you continue to receive this alert for half an hour after receiving the 1st alert, check for the disk usage for Common partition under "Disk Usage" tab in RTMT. If the disk usage shown under that tab is higher than configured 5/24/26, 3:34 AM System Error Messages for Cisco Unified Communications Manager 15 - Cisco https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/err_msgs/15_x/ccmalarms15.html 155/343