/mcpSynopsis Cisco functions The CciscoLineDevSpecificAcquire class explicitly acquires any CTI Controllable device in the Cisco Unified Communications Manager system, which needs to be opened in Super Provider mode. Explicit Acquire, on page 366 The CciscoLineDevSpecificDeacquire class explicitly de-acquires any CTI controllable device in the Cisco Unified Communications Manager system. Explicit De-Acquire, on page 366 The CCiscoLineDevSpecificRedirectFACCMC class redirects a call to another party while including a FAC, CMC, or both. Redirect FAC CMC, on page 367 The CCiscoLineDevSpecificBlindTransferFACCMC class blind transfers a call to another party while including a FAC, CMC, or both. Blind Transfer FAC CMC, on page 368 The CCiscoLineDevSpecificCTIPortThirdPartyMonitor class opens a CTI port in third-party mode. CTI Port Third Party Monitor, on page 369 The CciscoLineDevSpecificSendLineOpen class triggers actual line open from TSP side. Use this for delayed open mechanism. Send Line Open, on page 370 The CciscoLineSetIntercomSpeeddial class allows the application to set or reset SpeedDial/Label on an intercom line. Set Intercom SpeedDial, on page 371 The CciscoLineIntercomTalkback class allows the application to initiate talk back on an incoming Intercom call on an Intercom line. Intercom Talk Back, on page 372 The CciscoLineRedirectWithFeaturePriority class enables the application to redirect calls with specified priority. Redirect with Feature Priority, on page 373 The CCiscoLineDevSpecificStartCallMonitoring class allows applications to send a start monitoring request for the active call on a line. Start Call Monitoring, on page 373 The CCiscoLineDevSpecificStartCallRecording allows the application to send a recording request for the active call on that line. Start Call Recording, on page 375 The CCiscoLineDevSpecificStopCallRecording allows the application to stop recording a call on that line. StopCall Recording, on page 376 The CciscoLineDevSpecificSetIPv6AddressAndMode enables the application to set the IPv6 address and addressing mode during registration. Set IPv6 Address and Mode, on page 377 The CciscoLineDevSpecificSetRTPParamsForCallIPv6 class sets the RTP parameters for calls for which you must specify IPv6 address. Set RTP Parameters for IPv6 Calls, on page 378 Cisco Unified TAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 319 Cisco Device-Specific Extensions Cisco Line Device Specific Extensions