/mcpThis data structure defines each codec that is supported on a line. The limit specifies 18. The following description shows each member in the MEDIA_CAPS data structure: MediaPayload specifies an enumerated integer that contains one of the following values: enum { Media_Payload_G711Alaw64k = 2, Media_Payload_G711Alaw56k = 3, // "restricted" Media_Payload_G711Ulaw64k = 4, Media_Payload_G711Ulaw56k = 5, // "restricted" Media_Payload_G722_64k = 6, Media_Payload_G722_56k = 7, Media_Payload_G722_48k = 8, Media_Payload_G7231 = 9, Media_Payload_G728 = 10, Media_Payload_G729 = 11, Media_Payload_G729AnnexA = 12, Media_Payload_G729AnnexB = 15, Media_Payload_G729AnnexAwAnnexB = 16, Media_Payload_GSM_Full_Rate = 18, Media_Payload_GSM_Half_Rate = 19, Media_Payload_GSM_Enhanced_Full_Rate = 20, Media_Payload_Wide_Band_256k = 25, Media_Payload_Data64 = 32, Media_Payload_Data56 = 33, Media_Payload_GSM = 80, Media_Payload_G726_32K = 82, Media_Payload_G726_24K = 83, Media_Payload_G726_16K = 84, // Media_Payload_G729_B = 85, // Media_Payload_G729_B_LOW_COMPLEXITY = 86, } Media_PayloadType; Read MaxFramesPerPacket as MaxPacketSize. It specifies a 16-bit integer that indicates the maximum desired RTP packet size in milliseconds. Typically, this value gets set to 20. G723BitRate specifies a 6-byte field that contains either the G.723.1 information bit rate, or it gets ignored. The following list provides values for the G.723.1 field values: enum { Media_G723BRate_5_3 = 1, //5.3Kbps Media_G723BRate_6_4 = 2 //6.4Kbps } Media_G723BitRate; Set Status Messages CCiscoLineDevSpecific | +--CCiscoLineDevSpecificSetStatusMsgs Description Use the CCiscoLineDevSpecificSetStatusMsgs class to turn on or off the status messages for the line that the hLine parameter specifies. The Cisco Unified TSP supports the following flags: Cisco Unified TAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 355 Cisco Device-Specific Extensions Set Status Messages