/mcpCallAttribute_Recorded_UserInitiatedFromApp, CallAttribute_Recorded_UserInitiatedFromDevice } ; For recorded calls, if the application negotiates an extension less than 0x000C0000 the CallAttributeType is set to CallAttribute_RecordedCall. If the application negotiates an extension version equal to 0x000C0000 or higher, the CallAttributeType is set to CallAttribute_Recorded_Automatic, CallAttribute_Recorded_AppInitiatedSilent, CallAttribute_Recorded_UserInitiatedFromApp, or CallAttribute_Recorded_UserInitiatedFromDevice. Call Recording Enhancement Unified Communications Manager Release 9.0 the Call Recording feature is enhanced to allow user to start/stop current active call recording by pressing softkey on IP phone. Record key toggles between start and stop modes. When TAPI Application invokes Recording Start / Stop APIs it has the same effect as if the user pressed the Record key on his IP phone. In addition, applications can control whether or not the phone display indication of on-going recording. The data types that are used by Cisco TSP to report recording configuration and recording type to TAPI applications are re-worked in order to reflect the recent changes in UCM. Interface Changes • LineDevCaps::DevSpecific change (Cisco Extention 0x000C0000) LINEDEVCAPS, on page 252 • LineCallInfo::DevSpecific change (Cisco Extention 0x000C0000) LINECALLINFO, on page 324 • CciscoLineDevSpecificStartCallRecording Start Call Recording, on page 375 • CciscoLineDevSpecificStopCallRecording StopCall Recording, on page 376 Message Sequence There are no changes to the message sequence with this enhancement. Backward Compatability This feature is backward compatible. Call Recording for SIP or TLS Authenticated calls Prior to 12.5.1 version, the phones which are authenticated (phone with Security profile having Device Security Mode as Authenticated) were not allowed to make use of the Call Recording feature. Whereas, Non–Secured phones or Secured/ Encrypted phones could use Call Recording feature with Non- Secured or Secured recorders, respectively. With the release 12.5.1, Cisco UCM TAPI interface has been enhanced to allow recording in Authenticated Phones based on the value of the new service parameter Authenticated Phone Recording. The expectation is that the authenticated phones should also be allowed to make use of the Call Recording feature. It depends on value set in the newly added service parameter Authenticated Phone Recording which can be set to the following values: • Allow Recording – Authenticated Phones can be allowed to record the calls. Cisco Unified TAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 34 Features Supported by TSP Call Recording for SIP or TLS Authenticated calls