/mcpDescription Parameter Name Enter the name or IP address of the remote Syslog server that you want to use to accept Syslog messages. You can configure up to five remote Syslog servers to accept Syslog messages. If a server name is not specified, Cisco Unified Serviceability does not send the Syslog messages. Do not specify a Cisco Unified Communications Manager server as the destination because the Cisco Unified Communications Manager server does not accept Syslog messages from another server. Maximum length: 255 Allowed values: Provide a valid remote syslog server name with the following characters: • A-Z • a-z • 0-9 • . • - Remote Syslog Server Name 1 to Remote Syslog Server Name 5 Select the desired Syslog messages severity for the remote syslog server. All the syslog messages with selected or higher severity level are sent to remote syslog. If a remote server name is not specified, Cisco Unified Serviceability does not send the Syslog messages. Default setting: Error Syslog Severity for Remote Syslog Messages CUCReports Parameters Specifies the maximum number of seconds used when trying to establish a Unity Connection with another server. Increase this time if Unity Connection experiences issues on a slow network. Default setting: 10 Minimum: 5 Maximum: 120 Report Socket Unity Connection Timeout Specifies the maximum number of seconds used when reading data from another server. Increase this time if Unity Connection experiences issues on a slow network. Default setting: 60 Minimum: 5 Maximum: 600 Report Socket Read Timeout Service Parameters Service parameters for Unity Connection allow you to configure different services in Cisco Unified Serviceability.You can view a list of service parameters and the descriptions by selecting the question mark button in the Service Parameter Configuration window. If you turn off a service in Cisco Unified Serviceability, Unity Connection retains any updated service parameter values. If you start the service again, Unity Connection sets the service parameters to the changed values. To view and manage the service parameters, sign in to Cisco Unity Connection Administration, expand System Settings and select Service Parameters. System Administration Guide 214 System Settings Service Parameters