/mcpiso.3.6.1.2.1.2.2.1.1.3 = INTEGER: 3 iso.3.6.1.2.1.2.2.1.2.1 = STRING: "lo" iso.3.6.1.2.1.2.2.1.2.2 = STRING: "eth0" iso.3.6.1.2.1.2.2.1.2.3 = STRING: "eth1" iso.3.6.1.2.1.2.2.1.3.1 = INTEGER: 24 iso.3.6.1.2.1.2.2.1.3.2 = INTEGER: 6 iso.3.6.1.2.1.2.2.1.3.3 = INTEGER: 6 iso.3.6.1.2.1.2.2.1.4.1 = INTEGER: 16436 iso.3.6.1.2.1.2.2.1.4.2 = INTEGER: 1500 iso.3.6.1.2.1.2.2.1.4.3 = INTEGER: 1500 iso.3.6.1.2.1.2.2.1.5.1 = Gauge32: 0 iso.3.6.1.2.1.2.2.1.5.2 = Gauge32: 100000000 iso.3.6.1.2.1.2.2.1.5.3 = Gauge32: 10000000 iso.3.6.1.2.1.2.2.1.6.1 = Hex-STRING: 00 00 00 00 00 00 iso.3.6.1.2.1.2.2.1.6.2 = Hex-STRING: 00 16 35 5C 61 D0 iso.3.6.1.2.1.2.2.1.6.3 = Hex-STRING: 00 16 35 5C 61 CF iso.3.6.1.2.1.2.2.1.7.1 = INTEGER: 1 ..... If you provide an IP address of a remote host the command is executed on that remote host. You have to provide the IP address, not the domain name. Requirements Command privilege level: 1 Allowed during upgrade: No utils snmp get 3 This command gets the SNMP data for the specified MIB OID. Command Syntax utils snmp get 3 [system prompts you for the parameters] Usage Guidelines If you use this command on a specific OID (leaf) in the MIB, you will get the value of the MIB. The SNMP get output of system uptime iso.3.6.1.2.1.25.1.1.0 = Timeticks: (19836825) 2 days, 7:06:08.25 If you provide an IP address of a remote host, the command is executed on that remote host. You have to provide the IP address not the domain name. Requirements Command privilege level: 1 Allowed during upgrade: No utils system This command restarts the system on the same partition, restarts the system on the inactive partition, or shuts down the system. Cisco Emergency Responder Command Line Interface Guide for Release 15 132 CLI Commands utils snmp get 3