McDewey

set tls resumption-timeout This command sets the number of seconds after which the TLS resumption will not work and the sessions will be invalid. Command Syntax set tls resumption-timeout set tls resumption-timeout Syntax Description Description Parameters Enter a value up to 3600 seconds to configure. After the configured value, the TLS sessions are invalid. seconds Command Modes Administrator (admin:) Usage Guidelines Requirements Command privilege level: 1 Allowed during upgrade: Yes Applies to: Cisco Emergency Responder set tls trace Currently the set tls trace command is supported only for the HAProxy service. Cisco Emergency Responder does not support the HAProxy service and hence the following commands are not applicable. set tls trace disable This CLI command disables the TLS tracing for a service. After you disable the TLS trace for a service, the service automatically gets restarted. During the restart process, any functionality related to the service will be not reachable. Note Command Syntax set tls trace disable service Syntax Description Description Parameters Specifies the service that you use to disable TLS tracing. service Cisco Emergency Responder Command Line Interface Guide for Release 15 54 CLI Commands set tls resumption-timeout