McDewey

The administrator can change both the hostname and IP address by responding yes. To change just the hostname, respond no. Note set network ip eth0 This command sets the IP address for Ethernet interface 0. You cannot configure Ethernet interface 1. Before attempting this command, the administrator should have a valid DRF backup. Also, before attempting an IP address change, the administrator should perform the following: • verify that the cluster configuration does not have any configuration problems by executing show hcs cluster verify detailed • update the cluster configuration by executing set hcs cluster config • validate the cluster configuration by executing show hcs cluster verify detailed set network ip eth0 addr mask gw Syntax Description Description Parameters Specifies Ethernet interface 0. eth0 Represents the IP address that you want to assign. addr Represents the IP mask that you want to assign. mask Represents the IP default GW that you want to assign. gw Command Modes Administrator (admin:) Usage Guidelines The system asks whether you want to continue to execute this command. If you continue, this command restarts the following services: • NIC driver • NTP • CLM • Service Manager Caution Command Line Interface Reference Guide for Cisco Unified Communications Solutions, Release 15 and SUs 96 Set Commands set network ip eth0