Requirements Command privilege level: 1 Allowed during upgrade: No Applies to: Unified Communications Manager, IM and Presence Service on Unified Communications Manager, and Cisco Unity Connection. Example admin:set network ip eth0 ......

W A R N I N G

======================================================= Note: Please verify that the new ip address is unique across the cluster and, if DNS services are utilized, any DNS configuration is completed before proceeding. Note: Changing the IP address will automatically restart system services cluster wide. Note: The command should not be issued during normal operating hours.

set network ipv6 dhcp This command sets the DHCPv6 client on the server and enables IPv6 support. For changes to take effect, you must restart the server. set network ipv6 dhcp {enable | disable} [reboot] Syntax Description Description Parameters Sets the DHCPv6 client on the server. By default, the server does not restart after you enable the DHCPv6 client. For your changes to take effect, you must restart the server by either entering the reboot parameter or manually restarting the server. dhcp Enables IPv6 support. enable Disables IPv6 support. disable (Optional) Causes the server to automatically restart after you enter the command. reboot Command Modes Administrator (admin:) Requirements Command privilege level: 1 Allowed during upgrade: No Applies to: Unified Communications Manager, IM and Presence Service on Unified Communications Manager, and Cisco Unity Connection. Command Line Interface Reference Guide for Cisco Unified Communications Solutions, Release 15 and SUs 97 Set Commands set network ipv6 dhcp