/mcpDescription Parameters (Optional) Outputs the information to a file. The file option saves the information to platform/cli/fname.cap. The filename cannot contain the “.” character. file fname (Optional) Sets a count of the number of packets to capture. For screen output, the maximum count equals 1000, and, for file output, the maximum count equals 10,000. countnum (Optional) Sets the number of bytes of the packet to capture. For screen output, the maximum number of bytes equals 128, for file output, the maximum of bytes can be either 262144 bytes or ALL. sizebytes (Optional) Specifies the source address of the packet as a host name or IPV4 address. src addr (Optional) Specifies the destination address of the packet as a host name or IPV4 address. destaddr (Optional) Specifies the port number of the packet, either source or destination. portnum Command Modes Administrator (admin:) Requirements Command privilege level: 0 Allowed during upgrade: Yes Applies to: Unified Communications Manager, IM and Presence Service on Unified Communications Manager, and Cisco Unity Connection. utils network capture-rotate This command captures IP packets beyond the 100,000 packet limit of utils network capture. utils network capture-rotate {filefname} [sizebytes] [sizePerFilemegabytes ] {maxFiles num}[srcaddr] [destaddr] [portnum][host protocoladdr] Syntax Description Description Parameters Outputs the information to a file. Note The file will be saved in platform/cli/fname. fname should not contain the "." character. file fname The number of bytes of the packet to capture. Valid values include any number up to 65535 or ALL. The default is ALL. sizebytes The sizePerFile sets the value for the size of the log files. (Unit is millions of bytes.) The default value of sizePerFile is 25 MB. sizePerFile megabytes Command Line Interface Reference Guide for Cisco Unified Communications Solutions, Release 15 and SUs 317 Utils Commands utils network capture-rotate