/mcp• If you created a new softkey template, associate the template with the devices and then restart them. For more information, see Add a Softkey Template to a Common Device Configuration and Associate a Softkey Template with a Phone sections. What to do next Perform one of the following procedures: • Add a Softkey Template to a Common Device Configuration, on page 478 • Associate a Softkey Template with a Phone, on page 479 Associate a Softkey Template with a Common Device Configuration Optional. There are two ways to associate a softkey template with a phone: • Add the softkey template to the Phone Configuration. • Add the softkey template to the Common Device Configuration. The procedures in this section describe how to associate the softkey template with a Common Device Configuration. Follow these procedures if your system uses a Common Device Configuration to apply configuration options to phones. This is the most commonly used method for making a softkey template available to phones. To use the alternative method, see Associate a Softkey Template with a Phone, on page 479. Before you begin Configure a Softkey Template for Hunt Group, on page 477 Procedure Purpose Command or Action Add a Softkey Template to a Common Device Configuration, on page 478 Step 1 Associate a Common Device Configuration with a Phone, on page 479 Step 2 Add a Softkey Template to a Common Device Configuration Procedure Step 1 From Cisco Unified CM Administration, choose Device > Device Settings > Common Device Configuration. Step 2 Perform the following steps to create a new Common Device Configuration and associate the softkey template with it; otherwise, proceed to the next step. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 478 Receiving Calls Associate a Softkey Template with a Common Device Configuration