/mcpStep 5 Click Save. For devices that are already registered, you must restart the Cisco CallManager service for this new setting to be enabled. What to do next If you want to configure device mobility settings for an individual device, go to Enable Device Mobility for Individual Devices, on page 49. Otherwise, you can begin configuring the system for device mobility. Go to Configure a Physical Location, on page 49. Enable Device Mobility for Individual Devices Use this procedure to enable device mobility for an individual device. This configuration overrides the setting of the Device Mobility Mode clusterwide service parameter. Procedure Step 1 From Cisco Unified CM Administration, choose Device > Phone. Step 2 Click Find and select the device that you want to configure. Step 3 From the Device Mobility Mode drop-down list, choose one of the following: • On—Device mobility is enabled for this device. • Off—Device mobility is disabled for this device. • Default—The device uses the setting of the Device Mobility Mode clusterwide service parameter. This is the default setting. Step 4 Click Save. Configure a Physical Location Use this procedure to configure a physical location that you will assign to a device pool. Device Mobility uses the location of the device registration to assign an appropriate device pool. Procedure Step 1 From Cisco Unified CM Administration, choose System > Physical Location. Step 2 Click Add New. Step 3 Enter a Name for the location. Step 4 Enter a Description for the location. Step 5 Click Save. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 49 Remote Worker Features Enable Device Mobility for Individual Devices