/mcpAssociate Common Device Configuration with Phone Before you begin Perform one or both of the following as needed: • Configure Softkey Template for Built-In Conferencing, on page 520 • Configure Softkey Template for Shared Conferencing, on page 521 Procedure Step 1 From Cisco Unified CM Administration, choose Device > Phone. Step 2 Click Find and select the phone device to add the softkey template. Step 3 From the Common Device Configuration drop-down list, choose the common device configuration that contains the new softkey template. Step 4 Click Save. Step 5 Click Reset to update the phone settings. What to do next Perform one or both of the following: • Configure Barge for Built-In Conferencing, on page 524 • Configure Barge for Shared Conferencing, on page 525 Configure Barge for Built-In Conferencing Most Cisco Unified IP Phones include the built-in conference bridge capability; that is, these Cisco IP Phones have an internal DSP that acts as a small conference bridge to support the barge feature. It can support only a maximum of three parties that include the phone itself. Starting from firmware version 11.x, Cisco IP Phone 8800 Series have the capability to daisy chain the built-in bridge (BIB) feature. Procedure Step 1 From Cisco Unified CM Administration, choose System > Service Parameters and set the Built In Bridge Enable clusterwide service parameter to On. Note If this parameter is set to Off, configure barge for each phone by setting the Built in Bridge field in the Phone Configuration window. Step 2 Set the Party Entrance Tone clusterwide service parameter to True (required for tones) or configure the Party Entrance Tone field in the Directory Number Configuration window. Step 3 Set the Single Button Barge/CBarge Policy to Barge. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 524 Presence and Privacy Features Associate Common Device Configuration with Phone