McDewey

Configure Busy Lamp Field Status You can configure how the BLF status depicts Do Not Disturb by setting the BLF Status Depects DND service parameter. To set the BLF status, do the following: Before you begin • Busy Lamp Field (BLF) presence status for DND works only when all the registered devices for that shared line DN are set to DND. • If you're using Jabber for iOS or Jabber for Android on the same DN, they are considered registered, even when they are not registered but just configured. Note Generate a Phone Feature List, on page 5 Procedure Step 1 In Cisco Unified CM Administration, choose System > Service Parameters. Step 2 Choose the Cisco CallManager service for the server that you want to configure. Step 3 In the Clusterwide Parameters (System - Presence) pane, specify one of the following values for the BLF Status Depicts DND service parameter: • True—If Do Not Disturb is activated on the device, the BLF status indicator for the device or line appearance reflects the Do Not Disturb state. • False—If Do Not Disturb is activated on the device, the BLF status indicator for the device or line appearance reflects the actual device state. What to do next Perform one of the following procedures: Configure Do Not Disturb on a Common Phone Profile, on page 559 Apply Do Not Disturb Settings to the Phone, on page 560 Configure Do Not Disturb on a Common Phone Profile Common Phone Profiles allow you to configure Do Not Disturb settings and then apply those settings to a group of phones in your network that use that profile. Before you begin Configure Busy Lamp Field Status, on page 559 Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 559 Presence and Privacy Features Configure Busy Lamp Field Status