/mcpProcedure Step 1 From Cisco Unified CM Administration, choose Device > Device Settings > Common Phone Profile. Step 2 From the DND Option drop-down list, choose how you want the Do Not Disturb feature to handle incoming calls. • Call Reject—No incoming call information gets presented to the user. Depending on how you configure the DND Incoming Call Alert parameter, the phone may play a beep or display a flash notification of the call. • Ringer Off—This option turns off the ringer, but incoming call information gets presented to the device, so the user can accept the call. Note For mobile phones and dual-mode phones, you can only choose the Call Reject option. Step 3 From the Incoming Call Alert drop-down list, choose how you want to alert phone users of incoming calls while Do Not Disturb is turned on. • Disable—Both beep and flash notification of a call are for disabled. If you configured the DND Ringer Off option, incoming call information still gets displayed. However, for the DND Call Reject option, no call alerts display, and no information gets sent to the device. • Flash Only—The phone flashes for incoming calls. • Beep Only—The phone displays a flash alert for incoming calls. Step 4 Click Save. Apply Do Not Disturb Settings to the Phone This procedure describes how to apply Do Not Disturb settings on your Cisco Unified IP Phones. You can apply DND settings through the Phone Configuration window in Cisco Unified CM Administration, or you can apply DND settings to a Common Phone Profile and then apply that profile to your phone. Before you begin If you are using a Common Phone Profile, complete Configure Do Not Disturb on a Common Phone Profile, on page 559. Otherwise, complete Configure Busy Lamp Field Status, on page 559 Procedure Step 1 From Cisco Unified CM Administration, choose Device > Phone Step 2 Click Find and select the phone on which you want to configure Do Not Disturb. Step 3 If you want to apply Do Not Disturb settings from a Common Phone Profile, from the Common Phone Profile drop-down list, choose the profile on which you have configured Do Not Disturb. Step 4 Check the Do Not Disturb check box to enable Do Not Disturb on the phone. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 560 Presence and Privacy Features Apply Do Not Disturb Settings to the Phone