McDewey

Add a Device Pool to an Emergency Location Group Configure device pools to use an Emergency Location (ELIN) Group. Before you begin Configure Emergency Location Groups, on page 640 Procedure Step 1 From Cisco Unified CM Administration, choose System > Device Pool. Step 2 In the Find and List Device Pools window, if you are adding an existing device pool, click Find and choose the device pool from the list. If you are adding a new device pool click Add New. Step 3 In the Device Pool Configuration window, choose the ELIN group to which you want to add the device pool from the Emergency Location (ELIN) Group drop-down list. If you are adding a new device pool, fill out any other required fields. Step 4 Click Save. Add Device to an Emergency Location Group Configure a particular device to use a particular Emergency Location (ELIN) Group. If you want to use the device pool ELIN Group that is associated for this device, you can ignore this section. Configurations that are made at the device level will overwrite any configurations that were made at the device pool level. Note The devices that you add to the ELIN Group, should be added to the ELIN Group that represents the particular location at which those devices are located. Note Before you begin Add a Device Pool to an Emergency Location Group, on page 641 Procedure Step 1 From Cisco Unified CM Administration, choose Device > Phone. Note If you are using a type of phone that is not an IP phone, go to the relevant configuration page for that type of phone. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 641 Custom Features Add a Device Pool to an Emergency Location Group