/mcpSecurity Groups Security Groups are a subfeature of Enterprise Groups. Cisco Jabber users can also search for, and add, security groups to their contact list. To set up this feature, administrators must configure a customized LDAP filter and apply it to the configured LDAP directory sync. Security Groups are supported with Microsoft Active Directory only. Maximum Allowed Entries When configuring Enterprise Groups, make sure that you configure contact list maximums that handle groups • The maximum number of entries that are allowed in a contact list is the sum of the number of entries in the contact list and the number of entries in groups that are already added to the contact list. • Maximum entries in contact list = (number of entries in contact list) + (number of entries in groups) • When the Enterprise Groups feature is enabled, Cisco Jabber users can add the groups to the contact list if the number of entries in the contact list is less than the maximum allowed entries. If the maximum allowed entries is exceeded while the feature is disabled, the users are not restricted until the feature is enabled. If the user continues to be logged in after the feature is enabled, no error message is displayed. When the user logs out and logs in again, an error message is displayed that asks the users to clear the excess entries. Enterprise Groups Prerequisites This feature assumes that you already have an LDAP Directory sync schedule configured with the below conditions. For details on how to configure an LDAP Directory sync, see the "Import Users from LDAP Directory" chapter of the System Configuration Guide for Cisco Unified Communications Manager. • The Cisco DirSync service must be activated • The LDAP Directory sync must include both users and groups • Regular LDAP Directory syncs, as configured with the LDAP Directory Synchronization Schedule must be scheduled. Supported LDAP Directories Only Microsoft Active Directory is supported with enterprise groups. Enterprise Groups Configuration Task Flow Complete these tasks to configure the Enterprise Groups feature. Procedure Purpose Command or Action Confirm that your LDAP Directory sync includes both users and groups. Verify Group Sync from LDAP Directory, on page 659 Step 1 Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 658 Custom Features Enterprise Groups Prerequisites