/mcpThe default value is 32. The field range is from 1 to 100. Step 7 Choose one of the following options when the maximum number of callers in the queue is reached: • If you want subsequent calls to be disconnected, select Disconnect the call. • If you want subsequent calls to be routed to a secondary destination, select Route the call to this destination. Provide a specific device DN, shared line DN, or another hunt pilot DN. • (Optional) You may also select Full Queue Calling Search Space from the drop-down list. Used to determine which partition to search when attempting to complete a call. Step 8 In the Maximum Wait Time in Queue field, enter an integer value to set the maximum wait time, in seconds, in a queue. The default value is 900 seconds. The field range is from 10 to 3600 seconds. Step 9 Choose one of the following options when the maximum wait time is reached: • If you want that call to be disconnected, select Disconnect the call. • If you want that call to be routed to a secondary destination, select Route the call to this destination. Provide a specific device DN, shared line DN, or another hunt pilot DN. • (Optional) You may also select Maximum Wait Time Calling Search Space from the drop-down list. Used to determine which partition to search when attempting to complete a call. Step 10 When no line members are logged in or registered at the time of an incoming call, choose one of the following options: • If you need that call to be disconnected, select Disconnect the call. • If you need that call to be routed to a secondary destination, select Route the call to this destination. Provide a specific device DN, shared line DN, or another hunt pilot DN. • (Optional) You may also select No hunt members logged in or registered Calling Search Space from the drop-down list. Used to determine which partition to search when attempting to complete a call. Step 11 Click Save. Automatically Logout Hunt Member on No Answer Allows line members to log off the hunt list automatically. If an agent does not answer a queuing-enabled hunt pilot call, that agent will be logged off of the hunt group and will not receive additional hunt pilot calls unless he presses the "HLOG" soft key on the phone to log into the hunt pilot. Line members can log back in using the "HLOG" softkey or PLK. Procedure Step 1 In Cisco Unified Communications Manager Administration, choose Call Routing > Route/Hunt > Line Group to configure line groups. Step 2 Choose the line group that you need to configure from the Find and List Line Groups window. Step 3 Navigate to the Hunt Options section of the Line Group Configuration window. Step 4 Ensure that the Automatically Logout Hunt Member on No Answer check box is checked. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 745 Advanced Call Processing Automatically Logout Hunt Member on No Answer