McDewey

• non 0: Agent Greeting was successfully played • 0: Agent Greeting was not successfully played dwParam3 – result code Get IP and Port Event SLDSMT_RTP_GET_IP_PORT This event indicates that the application has to set the RTP Port and IP information using existing SetRTP devspecific Extension. The application has to set the RTP information only for Dynamically Registered CTI Ports or Route Points and for static Registered CTI Ports, application has to open the port used for registration. This event is available only if extension version 0x000B0000 or higher is negotiated. Note The format of the parameters follows: • dwParam1 – Message type -SLDSMT_RTP_GET_IP_PORT • dwParam2 – IP Addressing Capability (from highest order bit to lowest) • First twenty three bits blank • SetRTPInfo (twenty fourth bit from MSB or ninth bit from LSB) • IP addressing mode 8 bits • dwParam3 – reserved (0) MultiMedia Streams Data Notification Event SLDSMT_MULTIMEDIA_STREAMSDATA When MultiMediaStreams Data Information is changed on a Call, SLDSMT_MULTIMEDIA_STREAMSDATA message is sent to the application. The format of the parameters follows: LINE_DEVSPECIFIC hDevice – TAPI call handle dwParam1 – SLDSMT_MULTIMEDIA_STREAMSDATA dwParam2 – unused dwParam3 – unused Cisco Unified TAPI Developers Guide for Cisco Unified Communications Manager, Release 15 and SUs 418 Cisco Device-Specific Extensions Get IP and Port Event