McDewey

Repltimeout should be set to 21 Minutes. Commands to check/set the replication timeout: show tech repltimeout ( To check the current replication timeout value ) utils dbreplication setrepltimeout ( To set the replication timeout ) Steps 7 and 8 must be performed after the checklist is fulfilled: Checklist: All the nodes have the connectivity to each other. Refer to Step 5. • RPC is reachable. Refer to Step 3. • Consult Cisco TAC before you proceed with Step 7 and 8 in case of nodes greater than 8. • Perform the procedure in the off business hours. • Step 7. Repair All/Selective Tables for Database Replication If the utils dbreplication runtimestate command shows that there are error/mismatched tables, run the command: Utils dbreplication repair all Run the utils dbreplication runtimestate command to check the status again. Proceed to Step 8, if the status does not change. Step 8. Reset the Database Replication from Scratch Refer to the sequence to reset the database replication and start the process from scratch. utils dbreplication stop all  (Only on the publisher) utils dbreplication dropadmindb (First on all the subscribers one by one then the publisher) utils dbreplication reset all ( Only on the publisher ) To monitor the process, run the RTMT/utils dbreplication runtimestate command. Refer to the sequence to reset the database replication for a particular node: