/mcpStep 6 From the Application User drop-down list, choose the application user that you have configured for self-provisioning. Step 7 Click Save. Enable Self-Provisioning in a User Profile In order for users to be able to Self-Provision phones, the feature must be enabled in the user profile to which they are assigned. If you don’t know which user profile your users are using, you can open a user’s settings in the End User Configuration window and view the User Profile field to get the correct profile. Note Procedure Step 1 From Cisco Unified CM Administration, choose User Management > User Settings > User Profile. Step 2 Click Find and select the user profile to which the user is assigned. Step 3 Assign Universal Line Templates and Universal Device Templates to the user profile. Step 4 Configure user settings for Self-Provisioning: • Check the Allow End User to Provision their own phones check box. • Enter a limit for the number of phones a user can provision. The default is 10. • If you want users to be able to use self-provisioning to reassign a previously assigned phone, check the Allow Provisioning of a phone that is already assigned to a different End User setting in the user profile page associated with the end user of old device. Users can reassign a previously assigned phone only if this check box is enabled in the User Profile that is associated to the old device. Step 5 Click Save. Phone Migration Tasks After self-provisioning Authentication is setup, use any of the following procedures to migrate phones. Migrate Phones Using Self-Provisioning IVR (Administrator) Administrators can use this procedure to migrate Cisco IP Phones on behalf of an end user, or to migrate common phones (for example, a lobby phone). Before you begin Make sure that the old phone is in the "Unregistered" state before you proceed with migration. You can plug the new phone into the network, wait until the phone registers and then perform the migration tasks. Once the migration is successful, the device will re-register with the users phone configuration data. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 705 Device Management Enable Self-Provisioning in a User Profile