/mcpProcedure Purpose Command or Action Disable the autoregistration parameter before phone migration. Disable Autoregistration, on page 707 Step 1 Configure the default phone load before the phone migration service. Set Up Default Phone Load, on page 707 Step 2 Configure the required Self-Provisioning authentication settings. Configure Self-Provisioning Authentication, on page 708 Step 3 Choose the migration procedure that applies for you. The Phone Migration Service can be used Migrate phones using any of these procedures: Step 4 • Migrate Phones Using Phone Migration Service (Administrator), on page 708 by either administrators or phone users to migrate phones. • Migrate Phones Using Phone Migration Service (Phone Users), on page 709 Following the migration, view a report that shows Cisco IP Phones that are migrated. View Phone Migration Report, on page 711 Step 5 Disable Autoregistration To use the Phone Migration Service, autoregistration must be disabled. Procedure Step 1 In Cisco Unified CM Administration, choose System > Cisco Unified CM. Step 2 Click on the publisher node. Step 3 Check the Auto-registration Disabled on the Cisco Unified Communications Manager check box. Step 4 Confirm the ports that will be used for SIP registrations. In most cases, there is no need to change the ports from their default settings. Step 5 Click Save. Set Up Default Phone Load Use this procedure to set up the default phone load before the phone migration service. Procedure Step 1 From Cisco Unified CM Administration, choose Device > Device Settings > Device Defaults. Step 2 Select the required phone model for migration. Feature Configuration Guide for Cisco Unified Communications Manager, Release 15 and SUs 707 Device Management Disable Autoregistration